How To Repair Toilet Paper Holder

Download Article

Download Commodity

Toilet paper holders are held in place past tiny screws that hold the decorative portion onto a wall subclass screwed into the wall. Normal pushing and pulling on the decorative arms during the placing and removing of toilet newspaper rolls tin loosen the screws that concord the ringlet in identify, making the holder too loose to practise its job. Correct this problem as soon as information technology is noticed to avoid a bigger repair.

If you catch the loosening quickly plenty, you lot tin hands repair information technology in minutes with the right tools.

one

Examine the underside of the loose arm or escutcheon. There should exist a small hole with a screw inside it. This spiral may or may not accept a traditional "head" to it.^[1]
2

Remove the screw if possible by grasping its edges betwixt your index finger and pollex and gently twisting until information technology comes loose. ^[2]

Advertizing
3

Take the screw down to the hardware shop to go the correctly sized screwdriver to reinstall it tightly. These screws may take an eyeglass screwdriver or they may take a small-scale Allen primal; each manufacturer uses a different type of screw.^[3]
4

Reinsert the screw into the hole in the base of operations of the decorative arm or escutcheon.
five

Insert the screwdriver or Allen key into the spiral and tighten information technology firmly until the toilet paper holder is firmly back on the wall.

Advertisement

If the loose holder isn't fixed right away, the down pressure level of the loose arm may brand the spiral in the wall loosen too. This may strength the spiral downwardly into the plaster, making a larger hole than the screw requires.

one

Locate the screws on the bottom of the decorative arm or escutcheon. ^[four]
2

Remove the screws and set up them aside.
three

Lift off the decorative portion of the toilet newspaper off the bracket holding it to the wall.
4

Unscrew the bracket from the wall and set up the pieces bated.
5

Insert a wall anchor into the pigsty in the wall where the bracket screws had been. Make sure the wall ballast is large plenty to make full the hole so the screw will fit tightly.^[five]
6

Supercede the wall bracket and screw information technology back into identify.
7

Tighten the screws on the bracket.
8

Supersede the decorative portion of the toilet paper holder on the bracket. ^{[half dozen]}
nine

Tighten the small screws at the base of the arm or escutcheon to concord the toilet paper holder firmly in identify. ^[seven]

Advertising

Add New Question

Question

Why is the water level in the toilet bowl very low?

Because you have a venting problem in your plumbing system. Some other fixture is siphoning out and through the toilet. It could be a blockage in the venting, or information technology could exist a lack of venting entirely, or just inadequate venting and the toilet is siphoning itself upon each flush. You'll want to fix that.

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Video

Keep the screwdriver that fits the small screws at the base of the holder handy and tighten the spiral as soon as it starts to loosen to preclude bigger problems.
Take the wall screws with yous to the hardware store to detect wall anchors that will fit the blazon of wall and the size of screw.

Thank you for submitting a tip for review!

Advertising

Don't move the toilet newspaper holder's location unless y'all are unable to get the wall anchor to hold properly. The decorative part of the toilet paper holder may not be able to cover the sometime holes, leaving them visible.

Advert